SECTION 15 " R-D" RAILROAD INDUSTRIAL DISTRICT

A.   The front yard setback in any railroad industrial district shall be ten (10) feet.

B.   The side yard setback in any railroad industrial district shall be not less than five (5) feet except on street intersections where the side yard setback on the intersecting street shall be not less than fifteen (15) feet.

C.The rear yard setback in all railroad industrial districts shall be a minimum of ten (10) feet from the center of the streets.

D.   It shall be a policy of the Governing Body to issue permits for the construction of buildings in the railroad industrial districts on the basis of the actual widths and areas required by the builder to allow room for such building and its use to conform with this ordinance. Each proposal may be referred to the Planning Commission for study and recommendation.

E.  No building constructed in any railroad industrial district shall be more than forty (40) feet in height.

F.   The application for a building permit in railroad industrial districts shall be accompanied by a complete plot plan showing the proposed building or buildings and also the proposed use of the balance of the property. The plan shall show waste disposal, water supply, drainage, ingress and egress, landscaping, screening and other pertinent data. Distances to the surrounding buildings may also be shown on the plot plan. This plot plan shall also be accompanied by a signed authorization from the property owner. The Governing Body may submit these plans to the Planning Commission for consideration and recommendation. In any event no building permit shall be issued for any construction in a railroad industrial district until authorized by a majority vote of the Governing Body.